Government Contract | North Carolina
Treated Lumber

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information


Bid Alert No: 00000469328

Bid Title: Treated Lumber

Agency Bid No. Title: 201600059

Received Date: 01/26/2016

Close Date: 02/04/2016

Purchase Type: Not Stated

Delivery Point:

Delivery Date: Not Stated

Special Notices: Questions Due By 01/27/2016 02:00 PM

Specifications

Specifications include, but are not limited to:Lumber that is 2" to 4" thick and 2" to 4" wide shall conform to Structural Light Framing, Grade No. 1 Dense MC19. Lumber that is 2" to 4" thick and 6" wide or wider shall conform to Structural Joists and Planks, Grade No. 1 Dense MC19. Lumber that is 5" and thicker along the least dimension shall conform to Structural Lumber, Grade Dense Structural 72. Rough lumber will be acceptable except where surfacing is called for by the contract. Rough lumber may vary 1/4" from the dimensions shown on the contract or bill of material. 1082-3 TREATED TIMBER AND LUMBER (A) General Grade marked lumber will not be required. Brand or ink stamp each piece of treated lumber in accordance with the WPA Standard M6. (B) Bridges, Fender Systems and Piles Lumber for bridges that is 2" to 4" thick and 2" to 4" wide shall conform to Structural Light Framing, Grade No. 1 Dense. Lumber for bridges that is 2" to 4" thick and 6" wide and wider shall conform to Structural Joists and Planks, Grade No. 1 Dense. Lumber for bridges that is 5" and thicker along the least dimension shall conform to Structural Lumber, Grade Dense Structural 65. Lumber for fender systems shall conform to Structural Lumber, Grade Dense Structural 65. Timber for piles shall meet ASTM D25 except that the timber shall be Southern Pine, and have at least a 2" sap ring or a 3" sap ring where called for by the contract or where the preservative is creosote and the retention is greater than 18 lb. /cf. Section 1082 Rough lumber will be acceptable except 1 where surfacing is called for by the contract or bills of material. Rough lumber may vary 1/4" from the dimensions shown in the plans or bill of material. Dressed lumber may be 1/8" scant from the dimensions shown in the 4 plans or bill of material. A 1/4" tolerance in length will be permitted.

Product Codes: 54041, 54057

Agency Information


Issuing Agency: State of North Carolina - Department of Administration

State: North Carolina

Agency Type: State and Local

Contact: Ryan Longmire Division of Purchase and Contract, 116 West Jones Street, 4th FL, Raleigh, North Carolina, 27603

Phone: 919-807-4521

Email: ryan.longmire@doa.nc.gov

< PREVIOUS PAGE

GET A FREE
MARKET
ANALYSIS

FREE Market Analysis


Get a FREE 90-Day Market Analysis and see the bids you’ve been missing

GET BIDS NOW