Government Contract | Virginia
Street Planing and Resurfacing Program

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information

Bid Alert No: 00000551058

Bid Title: Street Planing and Resurfacing Program

Agency Bid No. Title: 15-16-123 2016 -17

Received Date: 04/22/2016

Close Date: 05/24/2016

Purchase Type: Not Stated

Delivery Point:

Delivery Date: Not Stated

Special Notices: Pre-Bid Conference 05/04/2016 10:00 AM


Specifications include, but are not limited to: Where directed by the Engineer or his designee, the contractor shall install VDOT No.21A aggregate to build up the edges of the roadway between the edge of the new pavement and the existing shoulder elevation. 4.2 Measurement and Payment: Aggregate for shoulder work will be measured and paid for in tons used and shall be verified by a ticket for each load used on the job sites. The contract unit price shall include tools and equipment for delivery, manipulation, and compaction of the stone. 5.0 EROSION AND SEDIMENT CONTROL - NOT USED IN THIS CONTRACT 6.0 ASPHALT PAVEMENT MILLING 6.1 Description: Where required, this work shall consist of the removal by milling, at the depths and limits specified, of the asphalt pavement for resurfacing; and, the disposal of the milled material at the designated waste site. 6.2 Procedures: 6.2.1 This milling work shall be performed with a pavement milling machine of a type that has operated successfully on work comparable to this project. 6.2.2 All equipment and vehicles in use under traffic shall operate flashing or rotating amber warning lights. In addition, trail vehicles shall be equipped with electronic flashing or sequential amber arrows. 6.2.3 This milling work shall be by the cold milling method incorporating a machine capable of cutting at least two inches deep in flexible pavement while leaving a uniformly cut surface capable of handling traffic safely when the milling operation is completed. The ground speed of the milling machine shall be independent of the cutting equipment. The machine shall have a self-contained water system for the control of dust and fine particles. The width of the machine shall allow for controlled traffic. 6.2.4 A sufficient number of passes or cuts shall be made so that irregularities or high spots are eliminated and the pavement surface is milled to the desired elevation. This milled surface shall be free from gouges, ridges, oil film, and other imperfections and shall have a mosaic appearance suitable as a riding surface

Product Codes: 91396, 91395, 91350

Agency Information

Issuing Agency: City of Danville

State: Virginia

Agency Type: State and Local

Contact: J. Gary Via, Purchasing Department Purchasing Department, 427 Patton Street, Room 304, Danville, Virginia, 24541

Phone: 434-799-6528

Fax: 434-799-5102




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing