Government Contract | Georgia
Rescue Pumper

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information

Bid Alert No: 00000425035

Bid Title: Rescue Pumper

Agency Bid No. Title: RFB2016-11

Received Date: 11/24/2015

Close Date: 12/21/2015

Purchase Type: Not Stated

Delivery Point: Barrow County, Georgia

Delivery Date: Not Stated

Special Notices: Questions Due By Optional 12/14/2015 05:00 PM, Bidder Preregistration


Specifications include, but are not limited to:The purpose of this request is to provide interested suppliers with the sufficient information to enable them to submit a uniform bid for the Countys review. Also, to set-forth a systematic method that will be fair and impartial to all parties concerned and to generate a response that can be equally evaluated by the County. GENERAL: Barrow County is in the process of securing sealed bids for one (1) Rescue Pumper or Equivalent per attached specifications, equipment and graphics (Exhibit A) for the Barrow County Emergency Services (Fire Division). Bidder must be an authorized dealer for a minimum of three (3) consecutive years for the fire apparatus of which you are submitting a bid. Manufacturer certification may be required. Special attention should be given to the technical schedule and conditions below. Regular Bid: Each supplier must comply with all requirements for a regular bid as directed or required by this notice. Notice is hereby given to all suppliers that if their bids are defective or irregular, the same may be rejected immediately. Uniform Bid: To facilitate comparative analysis and evaluation of quotations, it is desired that a uniform format be employed in structuring each bid. The required format will coincide with specifications given later in this notice. The suppliers degree of compliance with the requirements of this notice will be a factor in the subsequent evaluation and award of contract for these items. All instructions are to be considered an integral part of the RFB.The vehicle shall be equipped with a one-piece 10 high bumper made from 10 gauge (0.135 nominal) polished stainless steel for corrosion resistance, strength, and long lasting appearance. It shall be mounted directly to the front frame extensions for maximum strength. The bumper shall incorporate two (2) stiffening ribs. Front Bumper Extension The bumper shall be extended approximately 20 from the face of the cab as required. Bumper Gravel Shield The extended front bumper gravel shield shall be made of 1/8 (.125) aluminum treadplate material. BUMPER TRAYS Lid, Bumper Hose Tray The center bumper tray shall have a diamond plate lid. The lid shall be hinged and shall be secured in the closed position by a latch and held open with a pneumatic shock. Bumper Tray - Center A hose tray constructed of 1/8 aluminum shall be recessed into the front bumper extension. The tray shall be located in the center of the bumper and be approximately 14" deep (13" to the top of the slats). One inch thick aluminum slats shall be included in the bottom of the hose tray to aid in the dissipation of water from the tray. FRAME ASSEMBLY Frame Rail Construction The frame shall consist of two (2) C-channel frame rails with heavy-duty cross-members. Each frame rail shall have the following minimum specifications in order to minimize frame deflection under load and thereby improve vehicle ride and extend the life of the frame: Dimensions: 10-1/4 x 3-1/2 x 3/8 Material: 110,000-psi minimum yield strength, high strength, low alloy steel Section Modulus: 16.61 cu. in

Bid Related Documents

Download Document

Product Code: 07230

Agency Information

Issuing Agency: County of Barrow

State: Georgia

Agency Type: State and Local

Contact: Cindy Clack 233 East Broad Street, Winder, Georgia, 30680

Phone: 770-867-1977




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing