Government Contract | Georgia
Purchase of Traffic Signal Electrical Equipment, Material, and Line Hardware

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information

Bid Alert No: 00000474504

Bid Title: Purchase of Traffic Signal Electrical Equipment, Material, and Line Hardware

Agency Bid No. Title: BL019-16

Received Date: 02/01/2016

Close Date: 02/23/2016

Purchase Type: Not Stated

Delivery Point: Gwinnett County, Georgia

Delivery Date: Not Stated

Special Notices: Pre-Bid Conference Optional 02/09/2016 09:00 AM, Questions Due By 02/11/2016 03:00 PM, Bidder Preregistration, Bid Bond Required: 5%, Performance Bond Required: 100%, Payment Bond Required: 100%, Warranty Required


Specifications include, but are not limited to:School Flasher Cabinet Assembly Shall include a 0.125-inch or thicker sheet aluminum cabinet and have a smooth, uniform, natural finish. All external welds shall be made by using the Heliarc welding method; where as internal welds will be made by using the wire welding method. All welds shall be neatly formed and free of cracks, blow holes, and other irregularities. External spot welding is not acceptable. All external joints shall be welded. The cabinet dimensions shall be approximately 14 inches high x 14 inches wide x 7 inches deep. The door shall be furnished with a neoprene gasket that shall form a weather tight seal between the cabinet and door. The door shall be hinged on one side. The lock mounted on the inside of the door shall be a Corbin pin tumbler type lock with a number 2 key. The cabinet shall be equipped with 2 x 2 tabs on top and bottom to allow bolting or banding to poles. The equipment shall be mounted on a 0.125-in. thick aluminum back panel measuring approximately 13 in. x 13 in. Panels are to be mounted on stand offs pressed through the back wall of the enclosure. A barrier type eight position terminal block shall be used to terminate all wires. The terminations will be as follows: 1-AC+, 2-AC-, 3- Not used, 4-neutrial L-1, 5-neutrial L-2, 6-load 1, 7-load 2, 8-not used. All terminals shall be clearly marked on the panel adjacent to the terminal block by etching, permanent label, or a silk screening process. All neutral and earth ground terminals shall be bonded together. (Floating neutrals are not acceptable) Each cabinet will be supplied with an external antenna. The antenna shall have a minimum gain of 3db and be housed in a PVC pipe with a Meyers hub for mounting. The antenna shall have a minimum of fifteen feet of coax cable. A BNC (or equal) connector shall be installed on the coax cable for connection to the time switch. The following equipment shall be mounted on this panel: Connector Plug for RTC CPR2101 Programmable Time Switch Surge Arrestor ( EDCO SPA -100 -T ) or equivalent 115 VAC circuit breaker (Square D brand QOU 115series or equivalent) Flasher bracket with NEMA flasher socket base Copper grounding lug (for # 6 copper wire or larger) SOLAR POWERED FLASHER CABINET ASSEMBLY These cabinets shall be used for school zone flashers or for warning beacons that operate continuously.

Bid Related Documents

Download Document


Download Amendment

Product Codes: 55000, 55088, 55089, 28500, 28595

Agency Information

Issuing Agency: County of Gwinnett

State: Georgia

Agency Type: State and Local

Contact: Chris Duncan, Purchasing Division Purchasing Division, 75 Langley Drive, 2nd Floor, Lawrenceville, Georgia, 30046

Phone: 770-822-8741

Fax: 770-822-8735




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing