Government Contract | Nebraska
Large Scale Truck Chassis Minimum 60,000 GVWR Articulated Boom Crane, Heavy Duty Flatbead with Toolboxes and Rear Truck Bumper

Bid Information

Bid Alert No: 00000514418

Bid Title: Large Scale Truck Chassis Minimum 60,000 GVWR Articulated Boom Crane, Heavy Duty Flatbead with Toolboxes and Rear Truck Bumper

Agency Bid No. Title: 5169 OF

Received Date: 03/16/2016

Close Date: 03/30/2016

Purchase Type: Not Stated

Delivery Point: Department of Agriculture Weights & Measures Division, 301 Centennial Mall S FL 4, Lincoln, Nebraska, 68509

Delivery Date: Not Stated

Special Notices: Questions Due By Optional 03/21/2016, Warranty Required, Bidder Preregistration


Specifications include, but are not limited to:WHEEL BASEA. 240 from center line of front axle to trunnion.B. 155.5 cab to trunnion.C. 55 or 54 rear axle spacing.D. 55 lift axle spacing in front of rear axles.E. Shall be clear useable space above frame rails.F. Exhaust stack and heat shield shall be right side mounted with no exhaustcrossing over from rails.BRAKESA. Service brakes shall be six wheel full air with automatic slack adjusters.B. Two shoes per wheel, double anchored when brakes are drum brakes.C. Dust shield are required on all axles.D. A spring loaded parking brake system designed to automatically applyparking brakes to all four rear wheels when pressure in main air reservoirdrops below safe pressure with warning signal is required.E. Compressor shall be a single or two-stage water- cooled type with aminimum capacity of 17cfm.F. Bendix AD-IP dryer or original equipment manufacturers (OEM) equivalentrequired. May be dealer installed. Spin on filter required.G. Drain valve system for all air tanks must be accessible from side ofchassis.H. Must be equipped with trailer brake controls with hand control valve andTractor protection for straight truck. Must have all necessary lines andconnections mounted to rear of truck chassis.ENGINEA. Diesel, minimum actual displacement no less than 11 liters which mustmeet 400 bhp, 1,400 ft. /lbs. torque.B. Temperature controlled fan.C. Must have 110 volt ac engine coolant heater. Male receptacle with coverfor electrical wire for engine heater is to be sturdily mounted.D. Engine shall have glow-plugs or pre-heater to aid in cold weather starting.

Product Codes: 06535, 06594, 07208

Agency Information

Issuing Agency: State of Nebraska - Department of Administration

State: Nebraska

Agency Type: State and Local

Contact: State Purchasing Bureau, 1526 K Street, Suite 130, Lincoln, Nebraska, 68508

Fax: 402-471-2089




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing