Government Contract | Louisiana
Install Rollup Doors @ Hunt Correctional

Specifications include, but are not limited to:FURNISH & INSTALLProvide labor, materials, and equipment to complete installation of (1) Roll Up Door as per bid document specifications.Furnish & Install Lump Sum Job Door standard features to include the following:*The curtain shall be roll-formed, 80,000 PSI galvanized steel, 26 gauge steel sections interlocked and seamed together to form a continuous curtain*A vinyl strip shall be on each of the curtain's exterior sides to minimize steel-to-steel contact, enhancing door operation, minimizing curtain nesting and scratching.*Guide shall be roll-formed from 14-gauge steel, 3" wide with UHMW polyethylene rub strips on each edge of the guide.*Bottom bar shall be of extruded aluminum reinforced with roll formed steel angle and provided with a vinyl bulb-type astragal to ensure a consistent seal along the floor.*Counter balance assembly shall include "stepped" design steel rings, to ensure a tight and uniform curtain wrap.*locks shall be slide bolt type mounted on each end of the door's bottom bar assembly locking into the door guide,and made of 11 gauge steel.Roll Up Door as per bid document specifications.Furnish and Install Lump Sum JobDoor standard features to include the following:*Curtain slats will be f-265 flat faced galvanized paintedsteel.*Curtain will be provided with steel or malleable iron endlocks on alternate slats.*Wind locks will be used as required to meet design windload, minimum 20 psf.*Guides will be roll-formed steel channel or three structuralst6eel angles with weather stripping on exterior side.*Brackets will be hot rolled steel plate to support thebarrel, counter balance and hood. *Internal baffle to beprovided in hood.*Counter balance will be helical torsion springs housed ina steel pipe with a deflection limited to .03" per foot ofspan (width) and adjustable by6 means of an external tension wheel.*All non-galvanized, exposed, ferrous surfaces will receive one coat of rust inhibitive primer.NOTE: Hot dipped galvanized steel angle guides, bell mouths, bottom bars, head plates, operator mounting plates, rolled guides, tension wheels, release mechanisms(for fire doors) and wall mounting tubes can NOT be painted, NOR powder coat finished. The galvanizing process will not allow the additional applied finish to adhere properly to the metal.