Government Contract | South Carolina
Furnish, Deliver and Install New Auditorium Seating for Coker Room 005

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information

Bid Alert No: 00000448351

Bid Title: Furnish, Deliver and Install New Auditorium Seating for Coker Room 005

Agency Bid No. Title: USC-RFQ-2903-LW

Received Date: 12/24/2015

Close Date: 01/14/2016

Purchase Type: Not Stated

Delivery Point: University of South Carolina, Columbia, South Carolina

Delivery Date: Not Stated

Special Notices: Bidder Preregistration, Warranty Required


Specifications include, but are not limited to:A. Back: The back is made of a compound curved upholstered inner panel with wrap-aroundpolypropylene outer panel and two wings for attaching the back to the chair standards.The back is to be a minimum of 28 tall. Either a high back or a low back version may beselected by specification. For low back type the back shall be mounted to achieve backheights of 33 above the floor. Back adjusts to four (4) back angles from 13 through 21degrees. For high back type the back shall be mounted to achieve back heights of 35 above the floor. Back adjusts to three (3) back angles from 16 through 21 degrees. Twoback widths accommodate 19, 20, 21, 22, 23 and 24 chairs.1. Wrap around plastic outer panel is provided with a continuous return flangeextending 1 over the top and around the sides to provide fabric protection andstrength. The outer panel is 0.10 molded polypropylene plastic covering the rear,top and over the sides of the back including the back wings and extends below seatlevel to protect seat cushions. The plastic has a haircell textured surface to providean attractive mar-resistant appearance and is supplied in the manufacturersstandard colors.2. Inner structural panel consists of 0.10 minimum thickness 20% talc filledpolypropylene injection molded to compound curves with deep web reinforcing.Engineered resin inner panel construction provides freedom from worry of woodfatigue or damage from drying, moisture or aging. Along the lower rear of the panelthere shall be four (4) steel threaded inserts for attaching the back to the backwing.3. The upholstery fabric cover is fastened to the inner panel with staples for a tauntsculpted fit.4. Padding consists of molded polyurethane foam 2 thick. It shall be non-hardeningand non-oxidizing. It shall resist acids, alkalis, oils, greases, soaps, abrasions,moisture, mildew and tearing.5. Back wings to be 14 gage steel, die cut and formed to attach to the rear of the innerpanel using mating steel inserts and two threaded fasteners per back wing.

Bid Related Documents

Download Document

Product Codes: 42004, 91000, 91400

Agency Information

Issuing Agency: University of South Carolina

State: South Carolina

Agency Type: State and Local

Contact: Lana Widener, Purchasing Department USC Purchasing, 1600 Hampton St., Suite 606, Columbia, South Carolina, 29208

Phone: 803-777-7776

Fax: 803-777-2032




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing