Government Contract | Texas
Electrical, Roof: Info in Header

Bid Information

Bid Alert No: 00000418396

Bid Title: Electrical, Roof: Info in Header

Agency Bid No. Title: HOU16023

Received Date: 11/16/2015

Close Date: 11/20/2015

Purchase Type: Not Stated

Delivery Point: Dallas / TX, Dallas, Texas

Delivery Date: Not Stated

Special Notices: Bidder Preregistration


No additional specifications were given.. ROOF, JOIST FRAMING & RAFTERS:All structural roof framing members will bear approved grade stamps and will conform to all requirements of the City of Dallas Building Codes.A) All roof framing will be done in a workmanlike manner, using good quality framing lumber as specified of sufficient size and capacity to withstand the design loads and spans as required by the City of Dallas Building Codes.B) Rafters must be framed directly opposite of each other at the ridge. The size of the ridge board will be 2 greater than the width of the rafters on either side of it. (i.e) 2x8 ridge for 2x6 rafters.C) When the repair of a barge rafter is called for, the splice will be made on a 30 degree angle with a metal splice plate used on the back side of the rafter for support. The splice will be made in a workmanlike manner, so as to leave as little evidence of the repair as possible. When replacement of a barge rafter is called for, Contractor is to replace the entire rafter from ridge to tail.D) All sheathing used on the roof will be C-D or better APA rated sheathing, Exposure 1, or OSB exterior grade sheathing in a thickness specified by the Housing Inspector and as approved by the City of Dallas Building codes.

Product Codes: 91438, 91473

Agency Information

Issuing Agency: City of Dallas

State: Texas

Agency Type: State and Local

Contact: Richard Fields 1500 Marilla, 3AN, Dallas, Texas, 75201

Phone: 214-243-2129




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing