Government Contract | Georgia
Diesel Powered 7.3 Cubic Yard Volumetric Capacity Municipal Street Sweeper

Bid Information

Bid Alert No: 00000464116

Bid Title: Diesel Powered 7.3 Cubic Yard Volumetric Capacity Municipal Street Sweeper

Agency Bid No. Title: Not Stated

Received Date: 01/19/2016

Close Date: 02/02/2016

Purchase Type: Not Stated

Delivery Point: Thomasville, Georgia

Delivery Date: Not Stated

Special Notices: Warranty Required


Specifications include, but are not limited to:POWER UNIT______ The Sweeper power unit shall be a diesel fueled, water cooled, turbocharged Tier-3 industrial engine. Piston displacementshall not be less than 275 cubic inch developing not less than 99 HP @ 2400 RPM and 261 ft. lbs. torque @ 1600 RPM.Engine shall be 4 cycle, 4.19 inch bore and 5.00 inch stroke.______ Cylinder construction shall be wet sleeve type.______ Spin-on replacement type oil filter.______ A fuel/water separator shall be furnished.______ 12 volt ignition, electric starter and minimum 95 amp alternator with charge indicator gauge mounted on control console incab.______ Unit shall have an automatic shutdown system when coolant temperature is too high, coolant level is too low or oil pressureis too low.______ Unit shall share a 50 gallon fuel tank and batteries with chassis engine.______ Unit shall have a replaceable element, heavy duty dry type air cleaner.______ Injector pump shall have centrifugal type variable speed governor for speed control.______ An auxiliary engine air filter restriction indicator shall be mounted in the cab.DUST SEPARATOR______ Separation of the dirt and refuse from the air stream shall be accomplished within the hopper by means of a high-capacitymulti-pass cylindrical centrifugal single chamber dust separator with a minimum size of 20" diameter and 61 width. Theseparator shall be designed so that it will not plug with normally encountered debris.______ The dust separator shall have a minimum 24" x 61" curved, easy to open door allowing inspection and cleaning of theinterior. The door shall have an abrasion resistant bonded rubber lining material for long life.______ The entire dust separator inlet area shall be lined with a bolt-in replaceable, wear resistant rubber liner for long life.______ A 61" x 84" steel screen of not less than 13 gauge shall be provided to allow air to move freely from the hopper into thecentrifugal dust separator.______ Hopper screen shall be a split-screen design allowing drop-down and cleaning.______ Filters and baffles not acceptable due to increased cost of replacement and cleaning.HOPPER______ Hopper size to be approximately seven and three tenths (7.3) cubic yard volumetric measurement with an operating loadcapacity of not less than 6 cubic yards.______ Dumping shall be accomplished by means of hydraulically actuated cylinders attached to a rear door which shall have aminimum opening of 84" x 44" with a raker bar moving inside hopper as door is opened and closed to dump debris behindthe rear wheels.______ Hydraulic cylinder movement shall be controlled with the use of an electric toggle switch located on the side of the hopperand by a switch inside the cab.______ The hopper floor shall have a minimum of 22 degree slope.______ Hopper door shall be opened and closed hydraulically and be held in the closed position by means of a lock valve located inthe hydraulic dump circuit.______ A 9.75"x 29" inspection door shall be provided on both left and right side of the hopper for easy viewing inside hopper andinsertion of large debris.______ Hopper shall be maintained airtight through use of rubber seals on all doors and openings.______ Hopper suction inlet roof area shall have a bolt on replaceable wear resistant liner 3/8"x11"x10'.

Bid Related Documents

Download Document

Product Code: 76577

Agency Information

Issuing Agency: City of Thomasville

State: Georgia

Agency Type: State and Local

Contact: 111 Victoria Place, P. O. Box 1540, Thomasville, Georgia, 31792



FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing