Government Contract | Nevada

Find Open Contracts in the Architecture and Engineering Industry

Find Contracts Now

Bid Information

Bid Alert No: 00000455323

Bid Title: 56,000 GVW CAB & CHASSIS

Agency Bid No. Title: 8404

Received Date: 01/08/2016

Close Date: 01/19/2016

Purchase Type: Not Stated

Delivery Point:

Delivery Date: Not Stated

Special Notices: Questions Due By 01/05/2016 05:00 PM


Specifications include, but are not limited to:Heavy-duty "MAINTENANCE FREE" batteries, 12-volt with minimum CCA rating of 2500 at 0 degrees Fahrenheit. The end user prefers that the battery box be mounted as far forward as possible on left side of vehicle only, or inside of cab located under the passenger side seat.Specify C.C.A. Rating at 0 Deg. F. _________________________COMPLIES ___YES NO____BRAKES: Shall be equipped with non-asbestos lining. Minimum front 16-1/2" x 6", minimum rear 16-1/2" x 7"; service brakes shall be "S" cam type on front and rear wheels, full air with warning buzzer; air gauge shall be dash mounted; compressor shall be piston type, water cooled, to be engine crankcase lubricated. Rear brake chambers shall be type 30, and front brake chambers shall be type 20 (or equal). All brake chambers shall be of the sealed type. Brakes shall be equipped with dust shields or backing plate. Vehicle shall also be equipped with a heated air dryer with extended purge capabilities and installed in accordance with manufacturer's instructions. Air dryer must be easily accessible. Vehicle will be equipped with automatic slack adjusters on all wheels. Air service shall be installed and included on the rear of the vehicle frame for towing trailers equipped with air brakes. Airlines, hand control valve, and breakaway valve shall be installed by the truck manufacturer.Specify Front Brake Size ___________ Specify Rear Brake Size___________Specify Mfr. & No. of Air Dryer_________________________________________Parking brakes shall be spring actuated with manual release. Spring parking brake chambers shall be provided on both rear axles. A parking brake "ON" warning light will be installed. Brake system shall comply with Federal Law.COMPLIES ___YES NO____BUMPER: Front only, to be manufacturer's heavy-duty steel channel type; bumper to extend full width. If a front mounted PTO is provided, the manufacturer shall provide a minimum clearance of 12 inches between the rear of the bumper and the front of the radiator.Specify Clearance __________________________________COMPLIES ___YES NO____CAB: Aluminum or anti-corrosion treated material composition (such as: hot-dipped, galvanized, etc. Paint is not acceptable) 119 minimum BBC cab required to include: a minimum 75-degree tilt fiberglass hood with fenders and splash guards attached to hood, stainless steel door hinges or rust resistant internal door hinges, interior noise reduction package and thermal cab insulation in floor, walls and roof. Engine protrusion through or beyond the firewall into the cab area is unacceptable if access to the engine is through the cab area. Air ride cab is required.Specify Cab Material Composition (*) and BBC dimensio

Bid Related Documents

Download Document

Product Code: 07208

Agency Information

Issuing Agency: State of Nevada - Department of Administration

State: Nevada

Agency Type: State and Local

Contact: Marti Marsh, Purchasing Division

Phone: 775-684-0180

Fax: 775-684-0169




FREE Market Analysis

Get a FREE 90-Day Market Analysis and see the bids you’ve been missing